*****************************************
	        			      RELEASE NOTES

				*****************************************
	
				    Chelsio iSCSI Boot Option ROM for 
                                             T3-based adapters
		           


Version : 2.0.202
Date    : 07/05/2011
================================================================================================

1.CHANGES
------------------------------------------------

- Ping utility now does not depend on any parameters configured in the target configuration page.
- Unhook ISR and reset adapter when the discovered target iqn is not the same as the one stored 
  in the flash. This can happen when the target ip address is the same, iqn is different.
- Fixed issue where saving configuring parameters failed on SuperMicro X8STE.
- Fixed link-up failure during taret discovery and login on SuperMicro X8STE.
- Reduced data size by around 2.5K.
- Sending CHAP,None for the AuthMethod instead of None,CHAP during target login.
- Fixed link failure for twinax cable on S320CR-LP.
- Fixed slowness in discovering Netapp target.
- Fixed boot failure when iSCSI bios installs on SuperMicro X7DWE.
- Fixed EBDA corruption on DELL PowerEdge platforms.
- Increased tcp receive timeout from 5 seconds to 10 seconds.



2.Errata (Open Issues)
------------------------------------------------

Bug ID: 4065
Status: Not Resolved

Description: 
           Keyboard does not respond if our option rom co-exists with USB DVD drive on HP blade.

________________________________________________________________________________________________

Bug ID: 4341
Status: Not Resolved

Description:
          Unable to boot to CD-ROM, with iSCSCI ROM installed on SuperMicro X7DB3.



================================================================================================
================================================================================================



Version : 2.0.185
Date    : 09/23/2010
================================================================================================


1.CHANGES
------------------------------------------------

- Fixed Login to IET Open Enterprise Target with CHAP authentication enabled.
- Fixed CHAP support for Netapp target.
- Updated TwinAX PHY firmware
- Fixed VLAN support
- Fixed stack corruption causing failure to load Option ROM


2.Errata (Open Issues)
------------------------------------------------

Bug ID: 14569
Status: Not resolved

Description:
          iSCSI Boot option rom is not seen with SuperMicro X8STE. This is due to an 
	  interoperability issue with the hardware, where the advertised size of the Option 
          ROM by the adapter is not accepted.

________________________________________________________________________________________________


Bug ID: 14564
Status: Not resolved, use workaround

Description:
          Intermittent login failure with CHAP on IET target within the Option ROM 
          configuration utility.

Workaround:
          Retry the login in the configuration utility. This does not affect login during boot.

________________________________________________________________________________________________


Bug ID: 7922
Status: Not resolved, use workaround.

Description:
          Login to the Microsoft Stringbean iSCSI target fails if CHAP authentication is 
          enabled.

Workaround: 
         Do not enable CHAP authentication if using the Microsoft Stringbean target.
         


================================================================================================
================================================================================================



Version : 2.0.178
Date    : 12/24/2009
================================================================================================

1.CHANGES
------------------------------------------------

- Added new cards phy support and phy code updates
- Added support for upto 4 targets for discovery
- More accurate error reporting
- Fixed interop Netapp filer iSCSI target
- Fixed IBM Mezz card port 1 issue



2.Errata (Open Issues)
------------------------------------------------

Bug ID: 7922
Status: Not resolved, use workaround.

Description:
          Login to the Microsoft Stringbean iSCSI target fails if CHAP authentication is 
          enabled.

Workaround: 
         Do not enable CHAP authentication if using the Microsoft Stringbean target.

________________________________________________________________________________________________

Bug ID: 7738
Status: Not resolved, use workaround.

Description:
          Login to the IET Open Enterprise Target fails if CHAP authentication is enabled.

Workaround:
         Do not enable CHAP authentication if using the IET target.

         






************************************************************************************************
Copyright (C) 2011 Chelsio Communications.
All Rights Reserved


The information in this document is furnished for informational use only, is subject to change 
without notice, and should not be construed as a commitment by Chelsio Communications. Chelsio 
Communications assumes no responsibility or liability for any errors or inaccuracies that may 
appear in this document or any software that may be provided in association with this document. 
Except as permitted by such license, no part of this document may be reproduced, stored in a 
retrieval system,or transmitted in any form or by any means without the express written consent 
of Chelsio Communications.